DESIGN 150 PR-11 50 This product manual contains important information about the safe installation and use of this projector. Please read and f
LIGHT OUTPUT Design 150 manual.doc 10/12 ELECTRICAL DIAGRAM
Design 150 manual.doc 11/12COMPONENT ORDER CODES NAME PART NO. REMARK TRANSFORMER 040030038 THERMOSTAT 190010054 95℃/10A/250V CAPACITOR 140010011
PR Lighting Ltd 571 Yingbin Road Dashi Panyu Guangzhou 511430, China TEL: +86 (20) 8478 1888 FAX: +86 (20) 8478 602
INDEX SAFE USAGE OF THE PROJECTOR 3 INSTALLING THE PROJECTOR 4 FITTING THE LAMP 4 POWER CONNECTIONS 5 CONTROL CONNECTIONS 5 DMX TERMINATOR 6
SAFE USAGE OF THE PROJECTOR When unpacking and before disposing of the carton check there is no transportation damage before using the projector. K
INSTALLING THE PROJECTOR The unit was designed to make installation easy: it can be fitted on a floor, wall or ceiling as required and will opera
POWER CONNECTIONS The unit is supplied with a power cord. Should any other connections be required they must be carried out with the following conf
DMX TERMINATOR In the Controller mode, the DMX output has to be connected with a DMX terminator at the last fixture in the chain. This prevents elect
SETUP OPTIONS - PROJECTOR CONFIGURATION After the projector is switched on, the projector will reset automatically and then the display will show th
STAND-ALONE MODE Press the UP or DOWN button to select (self test), and then press ENTER button to confirm it. The projector will run in stand-al
TECHNICAL DATA VOLTAGES: 100/120/200/220/230/240V AC, 50Hz or 60Hz To Order. POWER CONSUMPTION: 200W @ 220V LAMP: Type : HSD150/
Comments to this Manuals